Most water meters have a small leak indicator on the dial. Depending on the model, it’s a tiny triangle, a star wheel or a blinking icon on a digital face, and it moves whenever water is flowing anywhere past the meter. Check it at two in the morning, with every tap closed and the sprinklers off, and it should be still. If it’s turning, something in the house is drinking water while everyone sleeps.
Many leaks never drip anywhere you can see. They run into a toilet bowl, soak into drywall, sink into the soil under a slab, or bleed out of a buried line beneath the lawn. A good way to think about them is by size, from the slow waste that quietly adds to the bill to the kind that can undermine a foundation.
Families in Hays County who need San Marcos leaks repair often start by calling garrettsplumbingtexas.com. Leak detection sits on the company’s main list of services, next to repiping in copper, PVC and PEX. Reviewers often mention prompt arrival and pricing that didn’t feel padded. Ronnie Garrett founded the business, and his family has worked in the trade for four generations.
The Leaks You Can Hear and Still Ignore
At the small end are dripping faucets and showerheads. A drip every couple of seconds feels harmless, but over a month it adds up to buckets of water, and in hard water country it also leaves mineral tracks that etch the finish on the fixture. The fix is usually modest. Single-handle faucets wear out cartridges, older compression faucets wear out rubber washers, and shower valves wear out seals and stems.
One reviewer of this crew described having a shower valve replaced without re-tiling the wall. That detail matters, because many homeowners put off a dripping shower thinking the repair means tearing out tile. Many valve bodies can be rebuilt or swapped from the front through the trim opening, and where that isn’t possible, a plumber can often go in through an access panel on the back side of the wall.
The Toilet That Runs Without Running
Toilets are the most underestimated leak in any house. A worn flapper lets tank water seep into the bowl, the fill valve tops the tank back up, and the cycle repeats all day. Usually it makes no noise at all. The City of Round Rock’s water team points out that most running toilets can’t be heard, and that a leaking toilet can waste up to 300 gallons of water per hour in the worst cases.
The test is simple. Put a few drops of food coloring in the tank, leave the toilet alone for around twenty minutes, and look in the bowl. If color shows up, water is getting past the flapper. A short or tangled lift chain, a warped flush valve seat and a fill valve set too high, so that water drains into the overflow tube, are the other usual suspects. A wax ring that has failed at the floor is a different kind of problem. It wastes little water, but it slowly rots the subfloor underneath.
Pinholes Inside the Walls
The next size up is supply pipe leaking inside walls and ceilings. In copper systems this often means pinhole leaks, tiny perforations caused by water chemistry, high velocity or poorly reamed joints from the original installation. The first clue might be a faint brown ring on a ceiling under a bathroom, paint that bubbles at the base of a wall, a baseboard that swells, or a musty smell in a closet that shares a wall with a shower.
Older houses in the area can carry other materials. CPVC gets brittle as it ages and can crack when someone bumps it. Galvanized steel rusts from the inside out. Polybutylene, the gray plastic used widely in the 1980s and 1990s, has a well-known record of sudden failures. When one material starts failing in several spots, patching each leak as it shows up usually turns into a long and expensive habit.
Under the Slab, Where Clay Moves
Most homes here sit on concrete slabs poured over clay soil, and that clay swells during wet stretches and shrinks hard in drought. Pipes running under or through the slab take that movement every season, along with abrasion wherever they rub against concrete or gravel. Hot water lines tend to fail first because heat makes them expand and contract repeatedly.
The clues for a slab leak are distinctive:
- A warm spot on tile or wood flooring, often in a line across a room
- The sound of running water when every fixture is off
- A water heater that seems to run constantly
- Cracks in flooring or drywall that seem to appear from nowhere
- Damp carpet pad or a patch of floor that stays darker than the rest
- A meter that keeps moving even with the outdoor lines shut off
Finding a slab leak is detective work, not demolition. Plumbers isolate the hot and cold sides with pressure tests, then pin down the spot with acoustic listening equipment, thermal cameras or tracer gas. Accuracy here decides whether a repair means one small hole in a closet floor or a trench across the kitchen.
Out Past the Foundation
The biggest leaks by volume tend to happen outside. The service line from the meter to the house can split from root pressure, ground movement or simple age, and a break there can soak a strip of lawn or let water collect in the meter box. Irrigation systems add their own share of cracked heads, broken laterals and valves that never fully close, and these often show up as one patch of grass that stays green in August.
Where the leak is decides who pays for it. Utilities generally maintain the line up to and including the meter, and the homeowner owns everything after it. If water is bubbling up near the curb or inside the meter box itself, call the utility before you call a plumber.
Choosing How to Fix It
Spot repair
When a single leak shows up in otherwise healthy pipe, cutting out the damaged section and splicing in new pipe is the sensible repair. Under a slab this means breaking a small opening in the concrete, fixing the line, and pressure-testing it before the floor gets patched.
Rerouting
If a slab line has failed once and the pipe around it looks worn, abandoning that run and sending new pipe through the attic or walls avoids future digging. PEX is particularly well suited to this because its flexibility lets it snake through framing with few fittings.
Whole-house repiping
When leaks come back in different rooms, or the house still has polybutylene or galvanized lines, replacing the whole supply system usually costs less than a string of emergency calls. It also tends to reset the clock for insurers and buyers.
Whatever repair you choose, keep the paperwork. Detection reports and invoices help with insurance claims for water damage, and some utilities will credit part of a high bill once a documented leak has been fixed. A pipe that leaks without a sound only stays hidden until the meter, the floor or the ceiling shows it, so a five-minute look at that dial now and then is one of the cheapest habits a homeowner can keep.
